NEWS
Process Tanks Relining

The aggressive nature of the caustic chemicals held within four process tanks caused a major leakage which required to be repaired. Surface preparation had to be undertaken in a restricted working environment. There could also be no disruption to the normal day-to-day operations ongoing throughout the site.

The tanks were drained and washed to remove salt and other potential contamination from the surface. All surfaces were abrasive blasted to Sa 2½ to achieve a minimum surface profile of 75μ. All edges, angles and welds were stripe coated with solvent-free, high temperature and chemically resistant Novolac epoxy Epo-chem™ RW 500. This was then followed by two full coats of Epo-chem™ RW 500.

The tanks were successfully relined simultaneously, just one week before the closure of the plant over the Christmas shutdown. Substantial time and cost savings were achieved using this solution as there was no disruption to the normal operating processes of the facility.

The following benefits were achieved by utilising this solution:

  • Solvent-free
  • Exceptional high temperature and chemical resistance
  • No disruption to daily working processes
  • Reduced H&S and Fire Hazards
unpainted grey metal process tank internals

After Surface Preparation

process tank painted in blue with two large unpainted pipes

Completed Application

2019-04-30T16:43:19+01:00

Contact Our Specialist Coating Advisors

Our coating specialists can suggest the right solution for your specific application.

Contact Coatings Advisor
View Our Brochure
Go to Top